Solar Water Heater Engineering WIFI APP Remote Intelligent High Low Temperature Difference Controller Switch

Package will include:

1 pcs wifi temperature difference thermostat

2 pcs waterproof sensor (cable length: 2m or 5m , buyer select one when place order)

 

special function:

Output: 1 way relay output .

●Remote switch device status, temperature and temperature difference value real-time synchronous feedback

●It can run independently without WIFI, realize the function of single machine control temperature difference

●The meter output can be turned on or off manually remotely or on site (when the set temperature value is not reached)

●Optional remote high temperature temperature alarm APP push function (need to open the permission on the mobile phone), the alarm value can be set

●The status of the temperature probe can be displayed, which is convenient for maintenance (for reference only)

●APP can display the actual temperature difference, start and stop temperature difference, high temperature zone and low temperature zone temperature

●Anti-freeze protection function, when the temperature in the high temperature zone is lower than 3 degrees, the cycle output is automatically turned on

●Heat collector high temperature protection, when the temperature in the high temperature zone is higher than 90 degrees, the output will be forced to shut down

●The main account can share the device with others, and the device can only be added to one main account

Note that the alarm requires both the device and the mobile phone to be online. Without the network, it is like making a call without a mobile phone signal!

Configuration process:

●Installation preparation:

●For Android phones, search for "Tuya Smart" in the application market and download and install the APP

●Search for "Tuya Smart" in the APP Store on Apple mobile phones and install the APP.

●After installing the APP, please use your mobile phone or email to register an account.

●Note that if you are using an Android phone, please use the system default font, otherwise the display will be confusing

The process of adding a device to the mobile APP:

1. Connect the wires according to the wiring diagram. After the first power-on, the device enters the WIFI configuration mode by default.

Note: If the device has been added to the APP and needs to be reconfigured, you need to press and hold the configuration key before powering on and then power on, until the digital tube

Show the circular running light and release the button, the device enters the WIFI configuration mode at this time

2. Open the APP and click the "+" icon in the upper right corner to select any device.

3. Click "Confirm that the indicator light is flashing fast" on the APP

4. Prompt to select a wifi with normal Internet access and enter the password. After confirming the password and entering it correctly, click "OK".

4.1 The device uses 2.4G wifi communication protocol and does not support 5G network temporarily.

4.2 If the network is set to hide or filter the MAC address, please ask the network administrator to enter the background to modify the settings, and then add the device.

5. The APP automatically starts configuration, and the device is successfully added when the progress bar reaches 100%.

6. After adding successfully, you can rename the device.

Note: After the addition is successful, the device will be automatically deleted from the current APP if it is reconfigured.

Configuration flowchart: (There may be slight differences after APP upgrade, just for reference)