Matsutec HA-017M marine GPS Receiver Antenna with NMEA0183 RS232 output nmea 0183 gps antenna with Marine VHF Antenna Mounts

Matsutec HA-017M marine GPS Receiver Antenna with NMEA0183 RS232 output nmea 0183 gps antenna with Marine VHF Antenna Mounts

White : TX , Green: RX , Red : VCC , Black : GND

High Sensitivity and Stability GPS/SBAS Receiver

MODEL: HA-017M

Highlights :

1. 50-Channel engine with over 1 million effective correlator

2. Less than 1 second Time To First Fix for Hot and Aided Starts

3. -160dBm SuperSense® acquisition and tracking sensitivity

4. Accelerated Startup at week signals for modules with KickStart feature

5. High immunity to jamming , advanced jamming suppression mechanism and Innovation RF architecture

6. Wide range of operating Voltage

PHYSICAL

Enclosure	High compact, corrosion-proof PC (polycarbonate) resin
Construction	Hermetically sealed, fully waterproof
Dimensions	90mm(D) X 110mm(H)
Weight	65g (w/o cable & connector)
Mounting	Pole mount to 1”-14 threaded pipe

ENVIRONMENTAL

Operating temperature	-30℃~ +85℃
Storage temperature	-40℃~ +90℃
Relative humidity	95% non-condensing
Waterproof	100% waterproof (IPX-7)

ELECTRICAL

Antenna Element

	Center Frequency	1575.42 MHz±1.023 MHz
	Absolute gain zenith	+5 dB typical
	Absolute gain 10°	-1 dB typical
	Axial ratio	3 dB max
	Output VSWR	1.5 max
	Output impedance	50 ohm

GPS Performance

	Receiver Type	50 Channels GPS L1 Frequency C/A Code
	Time-To-First-Fix2
	Cold Start( Autonomous)	32 s
	Warm Start( Autonomous)	32 s
	Hot Start ( Autonomous )	Less than 1 s
	Sensitivity
	Tracking & Navigation	-160 dBm
	Reacquisition	-160 dBm
	Cold Start( Autonomous)	-143 dBm
	Horizontal Position Accuracy
	Autonomous	Less than 2.5m
	SBAS	Less than 2.0m
	Dynamics	Less than 4 g
	Operational Limits Velocity	600 m/s

User Protocol :

	Protocols	NMEA0183 V2.0 @4800 Baud , 8N1
	NMEA Messages	RMC, GGA , GSA , GSV , GLL , VTG

Interface:

	Output	RS-232 Port
	Power Supply	DC 12-17V

Wire Link:

	Wire Color	Designation
	Red	VCC
	Black	Ground
	Green	Config
	White	TX

HA-017M can supply 12-17 VDC.

The wire: Red
and black Link power ,

green and
white link RS232, green TX+, white TX-

Please
be careful not to connect the signal wires (TX RX) to the positive or negative
poles of the power supply, otherwise the GPS receiver may be damaged.

If there are NMEA+ and NMEA-
on your device, you can connect as shown in the following example.
One ground(GND) wire is connected to the
negative pole of the power supply, and the other ground(GND) wire is connected
to NMEA-, TX wire is connected to NMEA+. The RX wire usually does not need to
be connected.